Verify Checksums (from checksum files)
With this function you can verify if your files are intact, for example after copying them over a network or when when using removable media to transfer files. You can verify if your files are correct using stored checksums or hashes. These can be created using the function
Create Checksum File(s) (CRC32, MD5, SHA1)....
Currently Total Commander can verify checksums or hashes in CRC32, MD5, SHA1, SHA2, SHA3 and BLAKE3 formats. Checksum files used to verify files can be in ANSI, UTF-8 (with BOM), or UTF-16 (with or without BOM) encoding.
The "Only Errors" checkbox allows you to view only rows where validation errors were reported, plus the summary.
There are three ways to use this function.
Verifying using checksum files:
1. Select the checksum file(s) you wish to use for verification, or ensure the cursor is on one.
2. Start the "Verify Checksums" function.
Verify using a checksum or hash on the Widows clipboard:
1. Copy the checksum or hash code to clipboard. (for example a code listed on the web page where you downloaded a file)
2. Put the cursor on the file you want to check.
3. Start the "Verify Checksums" function. There are checksum methods that generate the same checksum length, e.g. BLAKE3, SHA2-256 and SHA3-256. With these, you have to select the correct method in the dialog, otherwise an error will be shown. You can also use all suitable methods at the same time, but this is significantly slower.
Verify using a checksum contained in the name of the file itself:
1. Place the cursor on a file whose name contains a CRC32 checksum, or select one or more such files. The checksum must be in square brackets.
2. Start the "Verify Checksums" function.
The verification window that appears is running in a background process. You can switch back to Total Commander and continue working.
Files that fail verification will be selected in the active file panel and highlighted in the verification window. In the verification window, you can move from one failed file to the next/previous one by pressing Ctrl+Down/Up or by using the arrow buttons in the bottom left corner.
Hotkeys:
Ctrl+A Select entire result list
Ctrl+C Copy selected lines to the clipboard
ESC Abort (with confirmation)